Page 1 of 1

running 2 webcams 1for autoguide & 1 for imaging

Posted: Tue Feb 06, 2007 11:13 pm
by Dan
i'm already running 1 webcam in maxim dl for autoguiding thru the gpusb. i'm having trouble getting the other webcam running along side it for imaging. it loads both of them just fine, but when i expose in the guide setup, nothing happens. then when igo to the expose tab the autoguider camera takes the image. i know this sounds like maxim issue, but i thought just maybe i could recieve some advice here. ( oh buy the way the 2 webcams are different 1 is a phillips & 1 is microsoft.)

Posted: Wed Feb 07, 2007 8:59 am
by dpanderson
Dan,

Sorry, I don't have the relevant experience to help you on this one. Perhaps some other folks here or on some of the Yahoo groups could render assistance.

new stuff

Posted: Wed Feb 07, 2007 3:05 pm
by Dan
ya it's new. i'll let u know when i get it going how i did it (in for a penny, in for a pound!)