Page 1 of 1

maximdl and serial webcams

Posted: Fri Jun 09, 2006 3:28 am
by pete
I think I know the answer to this already but I will ask anyway.

I have a serial controlled lx webcam, canon 350d and a CB245 camera. Rather than using three different programs to use them Maximdl was recommended. However I cannot confirm that maxim will operate a serial webcam but I see that it will control the LXUSB module.

OK here goes

Is it possible to use maxim or do I have to buy the LXUSB module.?

cheers

Pete

ps The serial control is via a parallal - serial converter and then via a FTDI serial usb converter.

Posted: Fri Jun 09, 2006 12:51 pm
by dpanderson
Pete,

Sorry, I don't know the answer to this one. Drop a line to the folks that make Maxim and see what they have to say.

Posted: Fri Jun 09, 2006 1:05 pm
by pete
I have done Doug - thanks for the response though.

I knew I should have ordered one at the same time as the GPUSB. :oops: