Could not connect to EQ Mount
Posted: Fri Jun 11, 2021 6:41 pm
Could not connect to EQ Mount
Mount: Orion Sirius EQ-G
PC: Windows 10, 64 Bit
EQ Direct Interfacing: USB2EQ5, 8 pin, into hand controller jack
Downloaded and installed:
EQDIRCheck v1.0.0
Virtual COM Port Drivers for USB2EQ6 and USB2EQ5
Selected Windows; 2.12.36.1; setup executable
Read:
Application Note AN_396 FTDI Drivers Installation
Guide for Windows 10
FTDI Drivers Installation Guide for Windows 10
Didn’t run as administrator, cable connected as installing
COM6 and USB Serial Converter are shown in device manager, none have to be updated….
Completed successful driver Installation: “FTDI CDM Driver Package Ready to use”
Ran: EQDIR Check; COM6,9600,1000,1
CONNECT: “Could not connect to EQ Mount”
Please, any help or direction appreciated. Thank you
Mount: Orion Sirius EQ-G
PC: Windows 10, 64 Bit
EQ Direct Interfacing: USB2EQ5, 8 pin, into hand controller jack
Downloaded and installed:
EQDIRCheck v1.0.0
Virtual COM Port Drivers for USB2EQ6 and USB2EQ5
Selected Windows; 2.12.36.1; setup executable
Read:
Application Note AN_396 FTDI Drivers Installation
Guide for Windows 10
FTDI Drivers Installation Guide for Windows 10
Didn’t run as administrator, cable connected as installing
COM6 and USB Serial Converter are shown in device manager, none have to be updated….
Completed successful driver Installation: “FTDI CDM Driver Package Ready to use”
Ran: EQDIR Check; COM6,9600,1000,1
CONNECT: “Could not connect to EQ Mount”
Please, any help or direction appreciated. Thank you