Trying to figure out a problem with GPUSBCheck
Posted: Mon Aug 30, 2021 6:20 pm
I'm trying to get my old GPUSB cable up and running using 64 bit Windows 10. When I try to install GPUSBCheck, I'm getting an error during the software installation (please see the attached picture of the error message). Okay, well, I was going to send a picture, but even the compressed version was too large, so here's the error message.....
C:WINDOWS\system32\stdole2.tlb
Unable to register the type library: RegisterTypeLib failed: code 0x8002801C
Error accessing the OLE registry.
Click Retry to try again, Ignore to proceed anyway (not recommended), or Abort to cancel installation.
I stopped there.
I don't know if anyone has seen this before, but any guidance would be appreciate.
Thanks.
C:WINDOWS\system32\stdole2.tlb
Unable to register the type library: RegisterTypeLib failed: code 0x8002801C
Error accessing the OLE registry.
Click Retry to try again, Ignore to proceed anyway (not recommended), or Abort to cancel installation.
I stopped there.
I don't know if anyone has seen this before, but any guidance would be appreciate.
Thanks.