Has anyone added the guide port conversion kit to a single-axis eq3 motor drive hand controller?
Are there any instructions on how wire it up?
I have a GPUSB box and cables. I will purchase the conversion kit if I can get directions on how to wire it up to my single-axis controller. Searching the web tells me I am not alone in wanting to do this but I have not found any directions. Are the hand controllers really so different inside that I can't just use the existing instructions and only make the RA connections in my hand box?
Adding guide port conversion kit to single-axis eq3 hand box
-
- Site Admin
- Posts: 1048
- Joined: Fri Apr 28, 2006 1:34 pm
- Location: central Iowa
- Contact:
Re: Adding guide port conversion kit to single-axis eq3 hand box
If you would take it apart and email pictures of the top and bottom side of the printed circuit board, I will do my best to help out. My email address is doug@shoestringastronomy.com
Re: Adding guide port conversion kit to single-axis eq3 hand box
Thank you Doug. I will send you some photos right away.