Hello guys,
we are going to guide our NEQ3 Skywatcher Mount with PHD. The Handcontroller 3.xxof a friend is working well (10 minutes circle round stars). But my Handcontroller 2.05 doesn't work because there is no pc direct mode.
is it right, that i have to buy an EQDIR Adapter with an RS232 to USB converter to guide to mount with PHD???
Thanks for your reply
Karsten
Skyscan Handbox Ver. 2.05 and PHD
-
- Posts: 2
- Joined: Wed Jul 06, 2011 7:59 am
- Anti-spam question: Astronomy
-
- Site Admin
- Posts: 1049
- Joined: Fri Apr 28, 2006 1:34 pm
- Location: central Iowa
- Contact:
Re: Skyscan Handbox Ver. 2.05 and PHD
Yes, you will need either our USB2EQ6 or USB2EQ5 adapter cables found at http://store.shoestringastronomy.com/products_eq.htm. I am not sure which cable you need because I am not familiar with which handbox connector is on your mount.
-
- Posts: 2
- Joined: Wed Jul 06, 2011 7:59 am
- Anti-spam question: Astronomy
Re: Skyscan Handbox Ver. 2.05 and PHD
Ok Doug,
thanh you. For my understanding (I'm german)
I have to buy the EQDIR interface module from Shoestring Astronomy. That plugs into the hand controller jack on the mount with the skywatcher cable. Then I have to plug my USB-serial adapter to the EQDIR Interface and use the Celestron driver with EQMOD....
thanh you. For my understanding (I'm german)
I have to buy the EQDIR interface module from Shoestring Astronomy. That plugs into the hand controller jack on the mount with the skywatcher cable. Then I have to plug my USB-serial adapter to the EQDIR Interface and use the Celestron driver with EQMOD....